Grass Valley Profile Mix Effects Upgrad 100 Fibre Channel - Manual (Page 36)

PDR 100 Fibre Channel Installation
36 PDR 100 Fibre Channel Installation
Removing Old Boards
If you currently have a 2-channel PDR100 system, you must remove the Master
Disk Recorder board. If you currently have a 4-channel system, you must remove
the Master Disk Recorder and the Slave Disk Recorder boards. Also, for both
2-channel and 4-channel systems, if you currently have an Ethernet 10 BaseT
board, you must remove that board.
To remove the old Master and, if installed, Slave Disk Recorder boards:
1. Use the Torx tool with the T15 tip to remove the screws which secure each
board to the rear panel (see Figure 11 for an example).
2. Use the extraction lever on the front of each board and the extraction ring at
the back of each board to lift the circuit board free of the connectors on the
motherboard.
Figure 11. Typical Removal of a Full Size Board
9040-13
1
2