Grass Valley Profile Mix Effects Upgrad 100 Fibre Channel - Manual (Page 68)

PDR 100 Fibre Channel Installation
68 PDR 100 Fibre Channel Installation
To install the EMI foam gasket:
1. Use the Torx tool with the T15 tip to remove the screws which secure the
power supply to the side of the chassis.
2. Refer to
Ê
in Figure 28 and slide the power supply toward the front of the
chassis approximately 1 inch.
3. Remove the protective strip from the adhesive on the EMI gasket.
4. Carefully slip the gasket into the chassis between the power supply and the
rear panel and attach it to the chassis just below the power cord connector
cut-out as shown at
Ë
in Figure 28.
5. Slide the power supply back into its original position and secure it to the
chassis with the screws previously removed.
Figure 28. Installing the EMI Gasket
9674-29
1
2