Grass Valley Profile Mix Effects Upgrad 100 Fibre Channel - Manual (Page 60)

PDR 100 Fibre Channel Installation
60 PDR 100 Fibre Channel Installation
Installing the PCI Interconnect Board
The PCI Interconnect board has three connectors which attach to edge-board
contacts on the Slave EDR, the Master EDR, and the Fibre Channel boards. See
Figure 20.
Figure 20. PCI Interconnection Board
The PCI board connectors are keyed to ensure correct orientation and the bottom
of the board identifies the connectors as J1, J2, and J3. J2 is further identified as
MASTER. To install the PCI board, refer to Figure 21 and proceed as follows:
1. Hold the PCI with the connectors pointing down and the connector
identifications towards the rear of the Profile chassis.
2. Align the PCI connectors so that J1 is over the Slave EDR header connector,
Master J2 over the Master EDR header connector, and J3 over the Fibre
Channel header connector, and the connector keys are over the index notches
on the boards.
9674-15
Master
J1
J2
J3 Index Notch