Grass Valley Profile Mix Effects Upgrad 100 Fibre Channel - Manual (Page 32)

PDR 100 Fibre Channel Installation
32 PDR 100 Fibre Channel Installation
Board Retainer Brackets Removal
There are two retainer brackets located in the board area that must be removed in
order to remove circuit boards. One is slotted so that it holds full size boards in
place and helps maintain their alignment. Although the other bracket holds short
boards in place, it must also be removed to remove any full size boards. This
bracket has extenders which may be moved to adapt to the locations of any short
boards. See Figure 9 for locations and removals of the two board retainer brackets.
To remove the board hold-down brackets, refer to Figure 9 and:
1. Use the Torx tool with the T10 bit to remove retaining screw
Ê
for the top
slotted bracket from the side of the Profile chassis.
2. Lift bracket
Ë
up and out of the chassis.
3. Use the Torx tool with the T10 bit to remove retaining screw
Ì from the
middle of the short board bracket.
4. Lift bracket
Í
up and out of the chassis.