Grass Valley Profile Mix Effects Upgrad 100 Fibre Channel - Manual (Page 53)

Installing the Ethernet 10/100 BaseT Board
PDR 100 Fibre Channel Installation 53
Installing the Ethernet 10/100 BaseT Board
The Ethernet 10/100 BaseT board is a short board, which must be installed in slot
J3. See Figure 16 for an installation example and install the 10/100 baseT board as
follows:
1. If you did not have an Ethernet board, use the Torx tool with the T15 tip
remove the slot blank from J3.
2. Slip the 10/100 BaseT board into the board area aligning it with the
connectors in the motherboard at the bottom panel and the rear panel cutout
for J3.
3. Ensure that the board contacts are correctly aligned with the motherboard
connectors and firmly press down on the board until it is fully seated. Screw
holes in the board bracket should align with the two bracket mounting screw
holes, one on the inside and one on the outside of the rear panel.
4. Use the Torx tool with the T15 bit to secure the 10/100 BaseT board bracket
to the rear panel with the screw removed either when the old Ethernet board
was removed or when the slot blank was removed (step 1).