Grass Valley PDR 200 Service Manual - Manual (Page 86)

Chapter 5 Maintenance
5-4 PDR 200 Service Manual
CAUTION: Support the front panel during removal from the chassis so as to not
place stress on the LED cable.
4. Use the Torx tool with the T15 tip to remove the two screws on each side which secure
the handles and front panel to the chassis. See Figure 5-2.
Figure 5-2. Front Panel, Handles, and Gasket Removal
5. Carefully move the front panel away from the chassis.
6. Disconnect the LED cable connector from the chassis to the front panel and place the
front panel face down on a flat level surface.
7. Use the Torx tool with the T10 tip to remove the two screws holding the metal gasket
to the front panel.
9675-19
3 1
2
Disconnect
LED cable
!