Grass Valley PDR 200 Service Manual - Manual (Page 93)

PDR200 Service Manual 6-1
Chapter
6
Parts Removal and Replacement
This chapter identifies the replaceable parts in the PDR 200 and provides the
procedures to remove and replace them. The chapter also identifies the tools required
to perform the removal and replacement procedures.
NOTE: Do not discard any hardware unless specifically instructed to do so.
WARNING: To avoid serious injury from high currents, insure that the power cord
is disconnected prior to performing any removal and replacement procedure.
Tools Required
The tools required to perform the removal and replacement procedures are:
• Torx tool with T10 and T15 magnetic tips.
• Medium Phillips screwdriver.
• Small Phillips screwdriver.
• 11/32-inch and 3/16-inch nutdrivers.
• Small wire cutters.
!