HEIDENHAIN TNC 320 (77185x-01) ISO programming - Manual (Page 165)

Tool data 5.2
5
TNC 320 | User's Manual for DIN/ISO Programming | 3/2014
165
Pocket table for tool changer
The machine tool builder adapts the features of the
pocket table to the requirements of your machine.
Refer to your machine manual.
For automatic tool changing you need the a pocket table. You
manage the assignment of your tool changer in the pocket table.
The pocket table is in the
TNC:\TABLE directory. The machine tool
builder can adapt the name, path and content of the pocket table.
You can also select various layouts using soft keys in the
TABLE
FILTER menu.
Editing a pocket table in a Program Run operating mode
To select the tool table, press the TOOL TABLE
soft key.
Select the pocket table: Press the POCKET TABLE
soft key
Set the EDIT soft key to ON. On your machine this
might not be necessary or even possible. Refer to
your machine manual.