HEIDENHAIN TNC 320 (77185x-01) ISO programming - Manual (Page 434)

Positioning with Manual Data Input
14.1 Programming and executing simple machining operations
14
434
TNC 320 | User's Manual for DIN/ISO Programming | 3/2014
Example 2: Correcting workpiece misalignment on machines
with rotary tables
For running a basic rotation with the 3-D touch probe, see
"Touch Probe Cycles in the Manual Operation and El. Handwheel
modes of operation," section "Compensating workpiece
misalignment," in the Cycle Programming User's Manual.
Write down the rotation angle and cancel the basic rotation
Select operating mode: Positioning with MDI
Select the axis of the rotary table, enter the
rotation angle you wrote down previously and set
the feed rate. For example.
L C+2.561 F50
Conclude entry
Press the machine START button: The rotation of
the table corrects the misalignment