HEIDENHAIN TNC 320 (77185x-01) ISO programming - Manual (Page 50)

First Steps with the TNC 320
1.3 Programming the first part
1
50
TNC 320 | User's Manual for DIN/ISO Programming | 3/2014
Machine the contour and move to the contour
point 2 : You only need to enter the information
that changes. In other words, enter only the Y
coordinate 95 and save your entry with the
END
key
Approach contour point
3 : Enter the X coordinate
95 and save your entry with the END key
Define the chamfer at the contour point 3 : Enter
the chamfer width 10 mm and confirm with the
END key
Approach contour point
4 : Enter the Y coordinate 5
and save your entry with the END key
Define the chamfer at the contour point 4 : Enter
the chamfer width 20 mm and confirm with the
END key
Approach contour point
1 : Enter the X coordinate 5
and save your entry with the END key
Enter 27 to depart from the contour: Define the
rounding radius of the departing arc
Enter
0. To retract the tool, select : Press the
orange axis key Z in order to get clear in the tool
axis, and enter the value for the position to be
approached, e.g. 250. Press the
ENT key
Radius comp.: RL/RR/no comp.? confirm with the
ENT key: Activate no radius compensation
MISCELLANEOUS FUNCTION M? Enter M2 to enter
end of program, then confirm with the
END key.
The TNC saves the entered positioning block