HEIDENHAIN TNC 320 (77185x-01) ISO programming - Manual (Page 497)

Machine-specific user parameters 17.1
17
TNC 320 | User's Manual for DIN/ISO Programming | 3/2014
497
Parameter settings
DisplaySettings
Display step for the individual axes
List of all available axes
Display step for position display in mm or degrees
0.1
0.05
0.01
0.005
0.001
0.0005
0.0001
0.00005 (Display step software option)
0.00001 (Display step software option)
Display step for position display in inches
0.005
0.001
0.0005
0.0001
0.00005 (Display step software option)
0.00001 (Display step software option)
DisplaySettings
Definition of the unit of measure valid for the display
metric: Use the metric system
inch: Use the inch system
DisplaySettings
Format of the NC programs and cycle display
Program entry in HEIDENHAIN plain language or in DIN/ISO
HEIDENHAIN: Program entry in plain language in MDI mode
ISO: Program entry in MDI mode in DIN/ISO format
Depiction of the cycles
TNC_STD: Display the cycles with comments
TNC_PARAM: Display the cycles without comments