HEIDENHAIN TNC 320 (77185x-01) ISO programming - Manual (Page 496)

Tables and overviews
17.1 Machine-specific user parameters
17
496
TNC 320 | User's Manual for DIN/ISO Programming | 3/2014
Parameter list
Parameter settings
DisplaySettings
Settings for screen display
Sequence of displayed axes
[0] to [5]
Depends on the available axes
Type of position display in the position window
NOML.
ACTL
REF ACTL
REF NOML
LAG
DIST
Type of position display in the status display
NOML.
ACTL
REF ACTL
REF NOML
LAG
DIST
Definition of decimal separator for position display
.
Feed rate display in Manual Operation operating mode
At axis key: Display the feed rate only if an axis direction button is pressed
Always minimum: Always display the algebraic sign
Display of spindle position in the position display
During closed loop: Display spindle position only if spindle is in position control loop
During closed loop and M5: Display of spindle position if spindle is servo controlled
and M5 is active
Display or hide the PRESET TABLE soft key.
True: Preset table soft key is not displayed
False: Preset Table soft key is displayed