HEIDENHAIN TNC 320 (77185x-01) ISO programming - Manual (Page 56)

First Steps with the TNC 320
1.4 Graphically testing the first part
1
56
TNC 320 | User's Manual for DIN/ISO Programming | 3/2014
Starting the test run
Press the RESET + START soft key: The TNC
simulates the active program up to a programmed
break or to the program end
While the simulation is running, you can use the
soft keys to change views
Press the
STOP soft key: The TNC interrupts the
test run
Press the START soft key: the TNC resumes the
test run after an interruption.
Further information on this topic
Running a test run: see "Test Run", page 449
Graphic functions: see "Graphics ", page 438
Adjust the simulation speed: see "Speed of the Setting test
runs", page 439