Epson EMP-7950 - Manual (Page 100)

99 Monitoring and Controlling Projectors via a Network (for the EMP-7900)
User’s Guide
Compatible Computers
* Macintosh computers are not supported.
* Macintosh computers are not supported.
Installing and Uninstalling the Projector Software
The EMP Monitor and EMP NetworkManager software programs can be
installed separately from the accessory Projector Software CD-ROM as
required.
If using Windows 2000/NT4.0/XP, installation can only be carried out by a
user who is logged in as administrator.
PROCEDURE
Turn the power on for the computer and close all
applications that are currently running.
Insert the "Projector Software" CD-ROM into the
computer's CD-ROM drive.
The installer will start automatically.
A virus checking program window will appear, so
check the contents and then click "Next".
A software confirmation window will appear.
Computers that can run EMP Monitor
Operating System*
Windows 98 SE/Me/NT4.0/2000 Professional/
XP Home Edition/XP Professional
CPU
Pentium MMX 166 MHz or higher
(Pentium II 233 MHz or higher recommended)
RAM 64 MB or more (128 MB or more recommended)
Free hard disk space 6 MB or more
Display
XGAg (1024 × 768) resolution or higher,
16-bit colour or greater
Computers that can run EMP NetworkManager
Operating System*
Windows 98 SE/Me/NT4.0 (Service pack 6a, IE5.0 or
later)/2000 Professional/XP/XP Home Edition/
XP TabletPC Edition
CPU
Pentium MMX 166 MHz or higher
(Pentium II 233 MHz or higher recommended)
RAM 7 MB or more (10 MB or more recommended)
Free hard disk space 250 KB or more
Display
XGAg (1024 × 768) resolution or higher,
16-bit colour or greater
Installing the software
1
2
3
TIP
If the installer does not start running automatically, select "Run"
from the "Start" menu, then type "CD-ROM drive:\SETUP.exe" in
the window and click the "OK" button.