Epson EMP-7950 - Manual (Page 61)

60 Preventing theft (Password Protect)
User’s Guide
Setting Password Protect
Use the following procedure to set Password Protect.
PROCEDURE
Press the [Freeze] button on the remote control for
approximately five seconds.
If using the projector's control panel, hold down the
[ ] button and press the [Menu] button for
approximately five seconds.
The Password Protect menu will be displayed.
Turn "Power ON Protect" on.
(1) Select "Power ON Protect", and then press the [Enter]
button on the remote control or the [Auto/Enter] button on
the projector's control panel.
(2) Select "ON", and then press the [Enter] button on the
remote control or the [Auto/Enter] button on the
projector's control panel.
(3) Press the [ESC] button on either the remote control or the
projector's control panel.
If "Password Timer" is set to "ON", "Timer" can be
used to specify a time limit to use the projector
without entering the password.
If you don't use this setting, proceed to step 4.
(1) Select "Timer" and then press the [Enter] button on the
remote control or the [Auto/Enter] button on the
projector's control panel.
(2) Press the [Num] button on the remote control and use the
numeric buttons to enter a setting time within the range of
1 to 9999 hours, then press the [Enter] button on the
remote control or the [Auto/Enter] button on the
projector's control panel. If you make a mistake entering
the time, press the [ESC] button on either the remote
control or the projector's control panel and re-enter the
time.
When you have finished using the "Password Protect"
menu, the countdown for the elapsed time will start.
1
Remote control
Password Protect
ON : OFF
Password Timer
Power ON Protect
Set
[ / ] :Select [ ] :Set
Set 9999H Timer
0H Time-elapsed
User's Logo Protect
Passward
ON : OFF
ON : OFF
:
[Menu] :Exit
TIP
• If Password Protect has already been enabled, the screen requesting
a password will be displayed.
When the correct password has been entered, the "Password
Protect" menu will be displayed.
See"When Password Protect is enabled"
p.58
• When Password Protect has been set to "ON", attach the Password
Protect stickers to your preferred place on the projector to increase
anti-theft effectiveness.
2
3