Epson EMP-7950 - Manual (Page 76)

75 Functions for Enhancing Projection
User’s Guide
Use the [ ] button on the remote control or the [ ] or
[ ] button on the projector's control panel to select
the desired ID number (1–9).
Press the [Enter] button on the remote control or the [Auto/
Enter] button on the projector's control panel to accept the ID
number setting.
Once the setting has been made, press the [Menu]
button to close the configuration menu.
When the ID number is registered, the projector cannot be
operated by remote control unless the remote control used has
the same ID number or has an ID number of "0".
PROCEDURE
Press the [ID] button on the remote control.
The [ID] button will light.
Press the [0] to [9] buttons on the remote control to
specify the ID number for the remote control.
The light for the [ID] button will turn off and the registration
will be complete. If a number other than "0" is registered, the
remote control will only be able to operate projectors that have
the same ID number.
2
Brightness Control High Low : Video
Audio
Setting
User's Logo
Advanced1
About
Reset All
Projector ID
Network
Direct Power ON
Operation Lock
Reset Execute
: 6
[Menu]: Exit
Effect
Advanced2
COM Port
BNC Sync Termination ON OFF :
ON OFF :
ON OFF :
Set
Set
[ / ]: Select [ ESC ]: Return [ ]: Set
Auto Setup
: RS-232C USB
OFF : ON
3
Registering an ID Number for a Remote Control
1
Remote control
2
Remote control