Turning the power on and projecting images, P.36 – Epson EMP-7950 User Manual
Page 37
36
Turning the Projector On
User’s Guide
Turning the Power On and Projecting Images
PROCEDURE
Check that the indicator has stopped flashing and
is lit orange.
If using the remote control, set the [R/C] switch on the
remote control to "ON".
Turn the power on for all equipment connected to the
projector.
For a video source, press the [Play] button at the video source to
start playback if necessary.
Press the [Power] button on either the remote control
or the projector's control panel to turn the power on
for the projector.
The indicator flashes green. After a short period it stops
flashing and lights steadily, and projection starts.
Wait until the indicator lights green (it normally takes about
30 seconds to change).
TIP
• If Password Protect has been enabled, the Password Protect Release
screen will be displayed when the power is turned on.
Type in the password.
• If the "Advanced2" - "Operation Lock" menu setting is set to
"ON", none of the buttons on the projector's control panel will work
except for the [Power] button.
Use the remote control buttons at such times.
1
2
3
4
Remote control
Changes from flashing to lit green
TIP
• The remote control and projector's control panel buttons will not
function while the indicator is flashing green.
• Depending on the configuration menu settings, the message "No
Signal." may appear. See "Setting" - "No-Signal Msg."