Epson EMP-7950 - Manual (Page 107)

106 Monitoring and Controlling Projectors via a Network (for the EMP-7900)
User’s Guide
If an e-mail message with "EPSON Projector" in the subject line is sent to
the
IP addressg that have been set as mail notification destinations, the
message is a notification message saying that there is a problem with the
projector.
The following information will be contained in the body of the message.
Line 1 : The name of the projector where the problem has occurred
Line 2 : The IP address that has been set for the projector where the
problem has occurred
Line 3 : Details of the problem
The details of the problem are listed on separate lines. The following table
shows the details that are given in the message for each item.
* A (+) or (–) will be appended to the start of the message.
(+): When a projector problem has occurred
(–) : When a projector problem has been solved
If the name of the projector that you would like to set up mail notification
for does not appear in the window, use the following procedure to
manually connect the projector.
PROCEDURE
Start EMP NetworkManager.
Double-click [Projector address selection] in the
projector list display area.
If a Problem Notification is Sent By Mail
Message*/Cause Remedy
Internal error "Reading the Indicators" p.116
Fan related error
Sensor error
Lamp cover is open
Lamp timer failure
Lamp out
Internal temperature error
High-speed cooling in
progress
Lamp replacement
notification
No-signal
No image signals are being input to the projector.
Check the connection status or check that the
power for the signal source is turned on.
Connecting Manually
1
Projector
address... EMP482800... 192.168.0.8 PROJECTOR01 169.254.10.176 PROJECTOR02 169.254.10.177 PROJECTOR03 169.254.10.178 Room201 169.254.207.64
Room202 169.254.207.65 Room301 169.254.207.66 Room302 169.254.207.67 Room303 169.254.207.68 Room401 169.254.207.69
2