SMA SMC 9000TL Installation - Manual (Page 28)

28 SMC9-11TLRP-IA-en-51 Installation Manual
5 Mounting SMA Solar Technology AG
Additionally required mounting material (not included in the scope of delivery):
☐ At least two screws which are suitable for the weight of the inverter and the surface
☐ At least two washers that are suitable for the screws
☐ At least two wall plugs that are suitable for the mounting surface and for the screws
☐ If the inverter is to be secured against theft, at least one safety screw and one wall plug suitable
for the safety screw
WaHiw_Verletzungsgefahr durch hohes Gewicht
1. Ensure that there are no cables in the wall which could be damaged when drilling.
2. Align the wall mounting bracket horizontally on the wall and use it to mark the position of the
drill holes. Use at least one hole on the left-hand side and one on the right-hand side of the wall
mounting bracket.
3. Drill the holes and insert the wall plugs.
4. Secure the wall mounting bracket horizontally on the wall using screws and washers.
5.2 Mounting the Inverter
Risk of injury when lifting and from falling inverter
The inverter is heavy (see section 12 "Technical Data", page 82). Lifting the inverter incorrectly, or
if it falls during transportation or while attaching it to the wall mounting bracket result in a risk of
injury.
• Lift and transport the inverter into the mounting
position horizontally. Use the side recessed grips or
a steel rod (diameter: maximum 30 mm).