Yaskawa 1000 Series Drive Option - CANopen Technical Manual - Manual (Page 7)

3 Receiving
YASKAWA ELECTRIC SIEP C730600 45B 1000-Series Option SI-S3 Technical Manual 7
3 Receiving
Please perform the following tasks after receiving the CANopen Option:
• Inspect the CANopen Option for damage.
If the CANopen Option appears damaged upon receipt, contact the shipper immediately.
• Verify receipt of the correct model by checking the information on the PCB (see Figure 1 ).
• If you have received the wrong model or the CANopen Option does not function properly, contact your supplier.
◆
Contents and Packaging
Table 1 Contents of Package
◆
Tool Requirements
A Phillips screwdriver PH1(#1) or PH2(#2) is required to install the CANopen option card.
Note: Tools required to prepare CANopen cables for wiring are not listed in this manual.
Description: Option Card Ground Wire Screws (M3) LED Label Installation Manual
–
Quantity: 1 1 3 1 1
ERR RUN
MANUAL