3 receiving, Contents and packaging, Tool requirements – Yaskawa 1000 Series Drive Option - MECHATROLINK-II Technical Manual User Manual
Page 8: 3receiving
8
YASKAWA ELECTRIC SIEP C730600 50A YASKAWA AC Drive-Option Card MECHATROLINK-II Technical Manual
3 Receiving
3
Receiving
Please perform the following tasks after receiving the MECHATROLINK-II Option:
• Inspect the MECHATROLINK-II Option for damage.
If the MECHATROLINK-II Option appears damaged upon receipt, contact the shipper immediately.
• Verify receipt of the correct model by checking the information on the PCB (see
).
• If you have received the wrong model or the MECHATROLINK-II Option does not function properly, contact your
supplier.
Contents and Packaging
Table 1 Contents of Package
Tool Requirements
A Phillips screwdriver (#2 (M3)) U.S. standard size is required to install the MECHATROLINK-II Option.
Description:
Option Card
Ground Cable
Screws (M3)
LED Label
Installation Manual
Quantity:
1
1
3
1
1
SI-T3
RX
TX
ERR
RUN
MANUAL