Yaskawa SI-ES3 for V1000 - Manual (Page 5)

1 Preface and Safety
YASKAWA Europe YEU TOEP C710606 98A - V1000 Option EtherCAT - Installation Manual EN 5
For the drive setup, refer to one of the documentation listed below.
 Terms
Note: Indicates supplemental information that YASKAWA highly recommends be
followed. Content identified by Note: is not related to personnel safety or
equipment damage safety messages.
YASKAWA Drive
Refer to the manual of the drive this option card is being used with.
The instruction manual for the drive covers basic installation, wiring, operation
procedures, functions, troubleshooting, and maintenance information.
It also includes important information on parameter settings and how to tune the drive.
A Quick Start Guide is included with the drive. For the more detailed technical
manual, visit YASKAWA’s homepage.
Europe: http://www.yaskawa.eu.com
Japan: http://www.e-mechatronics.com
USA: http://www.yaskawa.com
Other areas: contact a YASKAWA representative
EtherCAT ® Option: YASKAWA AC Drive SI-ES3 EtherCAT ® option card
EtherCAT ® : Ethernet for Control Automation Technology, an open Ethernet-based network
NOID: Network Option Interface Driver (YASKAWA Interface driver)
Online-DRV: NOID processing mode, process (ctrl/resp) data is active
Online-DRVMB:
NOID processing mode, process resp data is active, ctrl data is on hold (Until MEMOBUS
process is complete)
Online-PRG: NOID processing mode, NO process (ctrl/resp) data is active
Host: YASKAWA drive 1000 series
JTAG:
Joint Test Action Group, an IEEE standard interface test port for test and programming
purposes
LED: Light Emitting Diode
OPT, Option: The unit described in this document
INV, Inverter: Host application to OPT
PCB: Printed Circuit Board
SPI: Serial Peripheral Interface Bus
FCS: Frame Check Sequence
INVR: Drive register number
ESI: EtherCAT Slave Information
STOP
(Hz)
(Hz)
(A)
(V)
Freq Reference
FWD / REV Sel
Output Freq
Output Current
Selected Monitor
Monitor
Verify
SetUpGuide
Parameter Set
Auto-Tuning
V1000
:
:
:
:
:
:
:
:
:
:
Risque de décharge
électrique.
Lire le manuel avant l'installation.
Attendre 5 minutes après la coupure de l'alimentation,
pour permettre la décharge des condensateurs.
Pour répondre aux exigences , s assurer que le
neutre soit relié à la terre, pour la série 400V.
Read manual before installing.
Wait 5 minutes for capacitor discharge after
disconnecting power supply.
To conform to requirements, make sure
to ground the supply neutral for 400V class.
Risk of electric shock. WARNING
AVERTISSEMENT