Xerox Phaser 3330 - Manual (Page 71)

Solutions Probable Causes
In the print driver Properties, select 2-Sided
Print on the Paper/Output tab. Incorrect setting
Paper Tray Fails to Close
Solution Probable Cause
Some debris or an object is blocking the tray. The paper tray does not close fully.
Printing Takes Too Long
Solutions Probable Causes
It takes more time to print on certain types of
special paper. Ensure that the paper type is set
properly in the driver and at the printer control
panel. The printer is set to a slower printing mode. For
example, the printer could be set to print on
Heavyweight paper.
It takes time for printing to start when the
printer is exiting of Power Saver mode. The printer is in Power Saver mode.
Determine if a print spooler or a computer
sharing the printer is buffering all print jobs and
then spooling them to the printer. Spooling can
slow print speeds. To test the speed of the
printer, print some information pages such as
the Office Demo Page. If the page prints at the
rated speed of the printer, you could have a
network or printer installation issue. For addi-
tional help, contact the system administrator. The way the printer was installed on the net-
work could be an issue.
Wait. No action needed. The job is complex.
Change the print-quality mode in the print
driver to Standard. The print-quality mode in the driver is set to
Enhanced.
Printer Fails to Print
Solutions Probable Causes
To clear the error, follow the onscreen prompts.
If the error persists, contact your Xerox representative. The printer has an error.
Load paper into the tray. The printer is out of paper.
Replace the empty toner cartridge. A toner cartridge is empty.
7-3 Xerox ® Phaser ® 3330 Printer
User Guide
Troubleshooting