Epson Z8250NL - Manual (Page 17)

Part Names and Functions
17
2 BNC input port For analog RGB signals from a computer and
component video signals from other video
sources.
3 Video input port For composite video signals from video sources.
4 S-Video input port For S-Video signals from video sources.
5 Cable holder When a thick heavy HDMI cable is connected to
the HDMI input port, run a commercially available
cable tie through this holder to prevent the cable
from disconnecting.
6 Computer input port For analog RGB signals from a computer and
component video signals from other video
sources.
7 Power inlet Connects to the power cable.
The shape may differ depending on your projector
model.
8 Remote port Connects the optional remote control cable set
and inputs signals from the remote control. When
the remote control cable is plugged into this port,
the remote receiver on the projector is disabled.
9 RS-232C port When controlling the projector from a computer
or controller, connect it with an RS-232C cable.
This port is for control use and should not
normally be used. s
p.135
10 Wireless LAN unit
port Connects to the optional wireless LAN unit.
s
p.192
Name Function
11 Monitor Out port Outputs to an external monitor the analog signal
from the computer connected to the Computer
input port or the BNC input port. This is not
available for component video signals or other
signals being input to any port other than the
Computer input port or the BNC input port.
s
p.187
12 SDI port
(PowerLite Pro
Z8450WUNL/
Z8455WUNL only) For SDI signals from a video equipment.
13 HDMI2 input port For video signals from HDMI compatible video
equipment and computers. This projector is
compatible with HDCP
g signals.
14 LAN port Connects a LAN cable to connect to a network.
s
p.187
Name Function