Rugged Cams Workhorse DVR 4 Channel User Manual
Page 130
129
(6) Tour setting
Preset
Used to move the PTZ camera up, down, right, and left, to zoom in the
image, and to control the focus to save the new setting
Up to eight settings may be defined. Setting numbers between 1 and 8
may be selected.
Tour
Automatically controls the
preset PTZ camera according to the
predefined order
Tour 1 is set as 9, and Tour 2, as 0.
Preset
maintenance
time
Tour interval (between 5 and 60 seconds)
Example - Tour feature when Tour 1 and Tour 2 are set as follows:
When 9 is pressed in PTZ mode:
Numbers are selected in the following order: 1 > 7 > 5 > 6.
Selecting 9 again disables the feature.
When 0 is pressed in PTZ mode:
Numbers are selected in the following order: 3 > 2 > 4 > 8.
Selecting 0 again disables the feature.
Tour1
Tour2
1
3
7
2
5
4
6
8
On the {PTZ Setup} menu, select the {Tour} sub-menu and go to the channel using the arrow
(STW X) buttons. Afterward, press the [Select]
button.
On the selection box, enable the Tour feature using the arrow (ST) and [Select]
buttons.