Avago Technologies 3ware 9650SE-12ML (Channel) User Manual
Page 216
Maintaining Your Controller
204
3ware SAS/SATA RAID Software User Guide, Version 9.5.1
To test the battery in a BBU in 3DM 2
1
On the menu bar, choose Monitor > Battery Backup.
2
On the Battery Backup page, click the Test Battery Capacity link.
Figure 90. Battery Backup Information Screen in 3DM
3
When a message cautions you that testing the battery will disable the
BBU for up to 24 hours, click OK to continue.
After the battery test starts, you will see the voltage start dropping;
eventually the battery voltage will say "LOW". This is part of the battery
test. After the voltage drops to a point, it will start charging again, and the
status will change to “Charging.” Eventually, the battery voltage will say
“OK” again.
Figure 91. BBU Information Screen While Battery is Testing