Temp sensor status, Power supply status, Slot summary – Avago Technologies 3ware 9650SE-12ML (Channel) User Manual
Page 222
Managing an Enclosure
210
3ware SAS/SATA RAID Software User Guide, Version 9.5.1
Temp Sensor Status
Below is a list of possible temperature sensor statuses.
Note that the temp sensor status indicates the temperature of the enclosure or
backplane. Drive temperature, if supported, is available on the Drive Details
page.
•
OK.
The temperature sensor is functioning normally.
•
Failure.
The temperature sensor is present, but is malfunctioning.
•
Not Installed.
There is no temperature sensor installed.
•
Unknown.
The status of the temperature sensor is not reportable.
•
Over Temp Warning.
Temperature is higher than normal operating
temperature.
•
Over Temp Fail.
Temperature is higher than safe operating temperature.
•
Under Temp Warning.
Temperature is colder than normal operating
temperature.
•
Under Temp Fail.
Temperature is lower than safe operating temperature.
Power Supply Status
The following is a list of possible power supply statuses.
•
OK.
The power supply is functioning normally.
•
Failure.
The power supply is present, but is malfunctioning.
•
Off.
The power supply is off.
•
Not Installed.
There is no power supply.
•
Unknown.
The status of the power supply is not reportable.
Slot Summary
The following is a list of possible slot statuses:
•
OK.
The slot is functioning normally.
•
Inserted.
A drive has been inserted in the slot.
•
Ready to Insert.
The slot is ready to accept a drive.
•
Ready to Remove.
The drive in the slot can be removed.