Avago Technologies 3ware 9650SE-12ML (Channel) User Manual
Page 92
3DM 2 (3ware Disk Manager) Introduction
80
3ware SAS/SATA RAID Software User Guide, Version 9.5.1
Shows the properties of controller phys for 9690SA RAID
controllers.
There are two ways to access this page. If you have a direct-
attached drive you can access this page from the Information
> Drive Information page by clicking the phy ID for the drive.
If all drives are connected via expanders, navigate to the
Management > Controller Settings page. Under Other
Controller Settings click the # link for Number of Controller
Phys.
Lets you view settings that affect the units on the current
controller and change some of those settings.
Controller-level settings that can be changed include
background task rate, Auto Rebuild, Auto-Carving, and Carve
Size. Some additional policies are shown that can only be
changed in the BIOS or CLI.
Unit-level settings include specifying the StorSave Profile and
enabling or disabling the Write Cache, Auto-Verify, Overwrite
ECC, Queuing, and Rapid RAID Recovery.
To see this page, choose
Management > Controller
Settings from the menu bar.
Lets you view and change the schedule for tasks that affect all
units on the current controller.
To see this page, choose Management > Scheduling from
the menu bar.
Lets you configure new units and make changes to existing
units.
To view this page, choose Management > Maintenance from
the menu bar.
Shows a list of alarms, including the specific alarm message,
and the exact date and time it occurred.
To view this page, choose Monitor > Alarms on the menu
bar.
Shows the status of a Battery Backup Unit (BBU), if one is
installed, and allows you to test the battery.
To view this page, choose Monitor > Battery Backup on the
menu bar.
Lists the installed and supported enclosures attached to your
3ware controller.
To view this page, choose Monitor > Enclosure Support on
the menu bar.
Table 8: List of 3DM Pages
3DM Page
Description