Avago Technologies 3ware 9650SE-12ML (Channel) - Manual (Page 98)

86 3ware SAS/SATA RAID Software User Guide, Version 9.5.1
7
Configuring Your Controller
This section describes how to view details about the controller, check its
status, and change configuration settings that affect the controller and all of
the drives connected to it. It is organized into the following sections:
• Viewing Information About a Controller
• About Controller Policies
• Viewing Controller Policies
• Setting the Auto Rebuild Policy
• Using Auto-Carving for Multi LUN Support
• Setting the Size of Volumes Created with Auto-Carving
• Enabling and Setting Up Staggered Spin-up
• Exporting JBOD Disks
• Viewing Information About a Phy
• Changing the Phy Link Speed
Viewing Information About a Controller
You can check the controller model, serial number, firmware and driver
versions, and the status of the 3ware RAID controller in your computer.
If you have more than one controller in your system, you can easily view
information about each one using 3DM. If you are working at the BIOS level
in 3BM, you access each controller separately.
To see details about a controller in 3DM
1 Start 3DM and log in as an administrator.
The 3DM Unit Information page appears, listing all the 3ware controllers
installed in your system.
The right-most column of the list shows the status of each controller.
Note: Background task rate is also set for all units on a controller. For information
about setting the task rate, see “Setting Background Task Rate” on page 172.