7 zero channel raid, Zero channel raid, Pci configuration record in serial eeprom – Avago Technologies LSI53C1030 User Manual
Page 58: Section 2.7, “zero channel raid
2-28
Functional Description
Version 2.2
Copyright © 2001, 2002, 2003 by LSI Logic Corporation. All rights reserved.
2.7 Zero Channel RAID
Zero channel RAID (ZCR) capabilities enable the LSI53C1030 to
respond to accesses from a PCI RAID controller card or chip that is able
to generate ZCR cycles. The LSI53C1030’s ZCR functionality is
controlled through the ZCR_EN/ and the IOPD_GNT/ signals. Both of
these signals have internal pull-ups and are active LOW.
The ZCR_EN/ signal enables ZCR support on the LSI53C1030. Pulling
ZCR_EN/ HIGH disables ZCR support on the LSI53C1030 and causes
the LSI53C1030 to behave as a normal PCI-X to Ultra320 SCSI
controller. When ZCR is disabled, the IOPD_GNT/ signal has no effect
on the LSI53C1030 operation.
Pulling ZCR_EN/ LOW enables ZCR operation. When ZCR is enabled,
the LSI53C1030 responds to PCI configuration cycles when the
IOPD_GNT/ and IDSEL signal are asserted. Connect the IOPD_GNT/
pin on the LSI53C1030 to the PCI GNT/ signal of the external I/O
processor. This allows the I/O processor to perform PCI configuration
Table 2.5
PCI Configuration Record in Serial EEPROM
EEPROM Address
Configuration Data
0x00
PCI Function [0]
, bits [7:0]
0x01
PCI Function [0]
, bits [15:8]
0x02
PCI Function [0]
, bits [7:0]
0x03
PCI Function [0]
, bits [15:8]
0x04
PCI Diagnostic Memory Size
0x05
Reserved
0x06
PCI Function [1]
, bits [7:0]
0x07
PCI Function [1]
, bits [15:8]
0x08
PCI Function [1]
, bits [7:0]
0x09
PCI Function [1]
, bits [15:8]
0x0A
Checksum