PLANET GS-5220-16S8C - Manual (Page 88)

User’s Manual of GS-5220 Series

Configured Link Speed Select any available link speed for the given switch port. Draw the menu bar to
select the mode.
 Auto - Setup Auto negotiation for copper interface.
 10Mbps HDX - Force sets 10Mbps/Half-Duplex mode.
 10Mbps FDX - Force sets 10Mbps/Full-Duplex mode.
 100Mbps HDX - Force sets 100Mbps/Half-Duplex mode.
 100Mbps FDX - Force sets 100Mbps/Full-Duplex mode.
 1Gbps FDX - Force sets 10000Mbps/Full-Duplex mode.
 Auto Fiber (10G) – Setup 10G firber port for negotiation
automatically.
 Disable - Shutdown the port manually.

Flow Control When Auto Speed is selected on a port, this section indicates the flow control
capability that is advertised to the link partner.
When a fixed-speed setting is selected, that is what is used. The Current Rx
column indicates whether pause frames on the port are obeyed, and the Current
Tx column indicates whether pause frames on the port are transmitted. The Rx
and Tx settings are determined by the result of the last Auto-Negotiation.
Check the configured column to use flow control. This setting is related to the
setting for Configured Link Speed.
 Maximum Frame Size Enter the maximum frame size allowed for the switch port, including FCS. The
allowed range is 1518 bytes to 10056 bytes.
 Excessive Collision
Mode
Configure port transmit collision behavior.
 Discard : Discard frame after 16 collisions (default).
 Restart : Restart back off algorithm after 16 collisions.
When set each port to run at 100M Full, 100M Half, 10M Full, and 10M Half-speed modes. The
Auto-MDIX function will disable.
Buttons
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
: Click to refresh the Page. Any changes made locally will be undone.
88