PLANET MGSW-28240F - Manual (Page 110)

User’s Manual of MGSW-28240F

1000Base-LX

100Base-FX
Display the speed of current SFP module. The speed value or description is
gotten from the SFP module. Different vendors of SFP modules might show
different speed information.
 Speed
Display the wavelength of current SFP module. The wavelength value is gotten
from the SFP module. Use this column to check if the wavelength values of two
nodes are matched while the fiber connection is failed.
 Wave Length(nm)
Display the support distance of current SFP module. The distance value is gotten
from the SFP module.
 Distance(m)
Display the temperature of current SFP module. The temperature value is gotten
from the SFP module.
 Temperature (C)
Display the voltage of current SFP module. The voltage value is gotten from the
SFP module.
 Voltage (V)
Display the ampere of current SFP module. The ampere value is gotten from the
SFP module.
 Current (mA)
Display the TX power of current SFP module. The TX power value is gotten from
the SFP module.
 TX Power (dBm)
Display the RX power of current SFP module. The RX power value is gotten from
the SFP module.
 RX Power (dBm)
Buttons
Auto-refresh : Check this box to enable an automatic refresh of the page at regular intervals.
: Click to refresh the page immediately.
4.4.5 Port Mirror
Configure port mirroring on this page. This function provides to monitor network traffic that forwards a copy of each incoming or
outgoing packet from one port of a network switch to another port where the packet can be studied. It enables the manager to
keep close track of switch performance and alter it if necessary.
 To debug network problems, selected traffic can be copied, or mirrored, to a mirror port where a frame analyzer can be
attached to analyze the frame flow.
 The Managed Switch can unobtrusively mirror traffic from any port to a monitor port. You can then attach a protocol
analyzer or RMON probe to this port to perform traffic analysis and verify connection integrity.
110