3 port isolate – PLANET WGSD-10020HP User Manual
Page 119
User’s Manual of WGSD-10020 Series
6. Repeat Steps 1 to 6 by setting up the VLAN Trunk port at the partner switch and add more VLANs to join the VLAN trunk.
Repeat Steps 1 to 3 to assign the Trunk port to the VLANs.
4.6.7.3 Port Isolate
The diagram shows how the Managed Switch handles isolated and promiscuous ports, and the each PC is not able to access
the isolated port of each other’s PCs. But they all need to access with the same server/AP/Printer. This section will show you
how to configure the port for the server – that could be accessed by each isolated port.
Setup steps
1. Assign Port Mode
Set Port-1~Port-4 in isolated port.
Set Port-5 and Port-6 in [promiscuous port. The screen in
Figure 4-6-17
appears.
Figure 4-6-17:
The Configuration of Isolated and Promiscuous Port
119