PLANET IAP-2000PE User Manual
Page 62
Advertising
User’s Manual of IAP-200x Series
-61-
Repeater Mode Configuration
In the Repeater mode, you can use the wireless AP to connect to the primary AP, for extending the wireless
coverage.
Step 1.
Choose Wireless Settings Basic to display the Basic Settings page.
Figure 4-21
Step 2.
In this page, set the channel of the wireless router to accord with the peer AP.
Step 3.
In the Wireless Distribution System (WDS) page, set the WDS mode to Repeater Mode, set the Phy
mode, encryption type, and Encryption key to accord with the peer router. Then enter the MAC address
of the peer AP. After finishing the settings, click the Apply button to save the settings. The IAP-2000 will
work in the Repeater mode.
Advertising