PLANET VIP-281SW - Manual (Page 10)

The default IP address of LAN port is 192.168.0.1. (The WAN port is DHCP client mode.) You also
could open your web browser, and insert http://192.168.0.1 in the address bar of your web browser to
logon Router web configuration page.
To start Router web configuration, you must have one of these web browsers installed on computer for
management
•
Microsoft Internet Explorer 6.00 or higher with Java support
Please locate your PC in the same network segment
(192.168.0.x) of Router. If you’re not familiar with TCP/IP
please refer to related chapter on user’s manual CD or
consult your network administrator for proper network
configurations.
Í
Note
Keypad commands
The Router series phone adapters support telephone keypad configurations, please connect analog
telephone set and refer to the following table for machine network configurations.
IVR Menu Choice Machine operation Parameter(s) Notes
#111# Set DHCP client None
WAN port will change to
DHCP Client
#112xxx*xxx*xxx*
xxx#
Setup Static IP Address
Use the * (star) key
when entering a decimal
point.
DHCP will be disabled and
system will change to the
Static IP type.
#113xxx*xxx*xxx*
xxx#
Set Network Mask
Use the * (star) key
when entering a decimal
point.
Must set Static IP first.
#114xxx*xxx*xxx*
xxx#
Set Gateway IP Address
Use the * (star) key
when entering a decimal
point.
Must set Static IP first.
#115xxx*xxx*xxx*
xxx#
Set Primary DNS Server
Use the * (star) key
when entering a decimal
point.
Must set Static IP first.
#190# Unlock None
Must unlock the protect
function before carry out
the firmware update
(#160#).
#195# Save Network Settings None
Must save network
settings after set up
network settings via
keypad.
- 10 -
,