PLANET VIP-281SW - Manual (Page 8)

Physical Interface & Button
Front Panel LED Indicators
LED State Descriptions
PWR
ON
Off
Router is power ON
Router is power Off
WAN
ON
Flashing
Off
Router network connection established
Data traffic on cable network
Waiting for network connection
LAN
ON
Flashing
Off
LAN is connected successfully
Data is transmitting
Ethernet not connected to PC
WPS
ON
Off
The Wi-Fi Protected Setup function is starting.
The Wi-Fi Protected Setup function is close
WLAN
Flashing
Off
Transmitting or receiving data through the Wireless LAN
Wireless LAN is no function
Phone
ON
Flashing
Off
Telephone Set is On-Hook
Ring Indication
Telephone Set is Off-Hook
Reset Button
- Pressing 1 second to reboot machine.
- Pressing 5 seconds to reset to the factory default setting
WPS Button
- Pressing 3 seconds to start the WPS function 2 minutes for client
connection.
- Pressing 10 seconds to enable or disable the wireless function.
Rear Panel Indicators
1 WAN
RJ-45 connector for Internet access, connected directly to
Switch/Hub through straight CAT-5 cable.
2 LAN
RJ-45 connector, to maintain the existing network structure,
connected directly to the PC through straight CAT-5 cable
3 FXS RJ-11 connector, connected directly to the analog phone.
4 12V DC 12V DC Power input outlet
5 Antenna
Used to connect the external antenna for accessing to 802.11b/g/n
wireless network
Í
Note
1. Machine LAN port default IP is http://192.168.0.1 . Press
RESET button on front panel over 5 seconds will reset the
VoIP Router to factory default value. (Except speed dial and
call forward settings)
2. Using the power supply that is not the one included in package
will cause damage and void the warranty for this product.
- 8 -