Figure 40 wds-p2p mode – PLANET WNAP-C3220 User Manual
Page 54
Advertising
User’s Manual of WNAP-C3220
- 54 -
AP MAC
Enter the interconnection equipment’s MAC address.
Channel
Select the channel according to interconnection equipment’s; the
devices on the two ends must be at the same channel.
Open Scan
Click this button, the AP will scan the nearby wireless devices
automatically and display the information in the table.
Select the device which needs to bridge and the AP will add the
device’s MAC address automatically and select the corresponding
channel.
Figure 4040 WDS-P2P mode
Step 4.
After finishing the setting, click Next to enter Security Settings page as shown in
Chapter
5.3.1
Advertising