Yaskawa Σ-V Series AC Servo Drives Rotational Motor Analog Voltage Reference - Manual (Page 30)

2 Digital Operator
2-2
2.1
Digital Operator
The Digital Operator is a device that can be used to display SERVOPACK status, execute utility functions, set
parameters, and monitor operation.
2.2 Digital Operator Connection
Use the external monitor connector (CN5) on the SERVOPACK to connect the digital operator. There are two
ways to connect the digital operator. These are as follows:
• Conventional connection
• Connection with an analog monitor unit (If using this method, the digital operator and another device, such
as a monitoring device, can be connected to the SERVOPACK at the same time).
The following table lists the devices and cables that are required for connection.
The connection methods are shown below.
2.3
Operation of Digital Operator
Operation examples of utility functions (Fn ), parameters (Pn ) and monitor displays (Un )
when using a digital operator are described in this chapter.
Operations can be also performed with SigmaWin+.
For more information on the usage of the digital operator, refer to Σ -V Series User’s Manual Operation of Dig-
ital Operator (Manual No.: SIEP S800000 55).
Connection Method Required Devices and Cables
Conventional
• Digital operator relay cable (model: JZSP-CF1S00-A3-E)
• Digital operator (model: JUSP-OP05A-1-E)
With an Analog Monitor Unit
• Analog monitor unit connection cable (model: JZSP-CF1S05-A3-E)
• Analog monitor unit (model: JUSP-PC001-E)
• Digital operator (model: JUSP-OP05A-1-E)
Digital
operator Relay cable
for digital
operator 㨂㧯㧹㧼 㧿㨂㧻㧺 㧯㧻㧵㧺 㨀㧳㧻㧺 4'( 㧯㧴㧭㧾㧳㧱
#.#4/
㧰㧭㨀㧭 㧶㧻㧳 5810
㧿㧯㧾㧻㧸㧸 㧹㧻㧰㧱㧛㧿㧱㨀 㧾㧱㧿㧱㨀
5'481 4'#& 94+6' 5'481
;#5-#9#
&+)+6#.12'4#614㧶㨁㧿㧼г㧻㧼㧜㧡㧭г㧝г㧱
<Conventional Connection>
<Connection with an Analog Monitor Unit>
Digital
operator Connection cable
for analog monitor unit Analog
monitor unit 㨂㧯㧹㧼 㧿㨂㧻㧺 㧯㧻㧵㧺 㨀㧳㧻㧺 4'( 㧯㧴㧭㧾㧳㧱
#.#4/
㧰㧭㨀㧭 㧶㧻㧳 5810
㧿㧯㧾㧻㧸㧸 㧹㧻㧰㧱㧛㧿㧱㨀 㧾㧱㧿㧱㨀
5'481 4'#& 94+6' 5'481
;#5-#9#
&+)+6#.12'4#614㧶㨁㧿㧼г㧻㧼㧜㧡㧭г㧝г㧱
Analog