Epson PowerLite U50 3700-Lumen WUXGA 3LCD Projector - Manual (Page 137)

137
4. Select Projector ID and press Enter .
5. Press the arrow buttons on the remote control to select the identification number you want to use for
the projector. Then press
Enter .
Repeat these steps for all the other projectors you want to operate from one remote control.
Note: If you don't know the projector's ID, aim the remote control at the projector and press the ID button
to temporarily display the projector's ID on the screen.
Parent topic: Projector Identification System for Multiple Projector Control
Setting the Remote Control ID
The remote control's ID is set to zero by default so it can operate any compatible projector. If you want to
set the remote control to operate only a particular projector, you need to set the remote control's ID to
match the projector's ID.
Note: You must set the remote control ID to match the projector ID each time you turn on the projector
you have set it to control.
1. Turn on the projector you want the remote control to operate with exclusively.
2. Aim the remote control at that projector and press the ID button on the remote control.
The current projector ID is displayed on the screen for about 3 seconds.