Asus ProZ790-CREATOR WIFI LGA 1700 ATX Motherboard - Manual (Page 34)

34 PRIME / ProArt / TUF GAMING Intel 700 Series BIOS Manual
Controller 0, Channel 1 Control
Allows you to enable or disable Controller 0, Channel 1.
Configuration options: [Enabled] [Disabled]
Controller 1, Channel 0 Control
Allows you to enable or disable Controller 1, Channel 0.
Configuration options: [Enabled] [Disabled]
Controller 1, Channel 1 Control
Allows you to enable or disable Controller 1, Channel 1.
Configuration options: [Enabled] [Disabled]
MC_Vref0-2
Configuration options: [Auto] [0] - [65533]
Fine Granularity Refresh mode
Configuration options: [Auto] [Disabled] [Enabled]
DRAM SPD Configuration
SDRAM Density Per Die
Configuration options: [Auto] [4 Gb] [8 Gb] [12 Gb] [16 Gb] [24 Gb] [32 Gb] [48 Gb] [64
Gb]
SDRAM Banks Per Bank Group
Configuration options: [Auto] [1 bank per bank group] [2 bank per bank group] [4 bank per
bank group]
SDRAM Bank Groups
Configuration options: [Auto] [1 bank group] [2 bank groups] [4 bank groups] [8 bank
groups]
Configure Memory Dynamic Frequency Switching
The following item appears only when Realtime Memory Frequency is set to [Disabled] .
Dynamic Memory Boost
Allows you to enable or disable Dynamic Memory Boost Feature. Allows automatic
switching between default SPD Profile frequency and selected XMP profile frequency.
Only valid if an XMP Profile is selected.
Configuration options: [Disabled] [Enabled]
The following item appears only when Dynamic Memory Boost is set to [Disabled] .
Realtime Memory Frequency
Allows you to enable or disable Memory Frequency feature. Allows manual switching
between in runtime between default SPD Profile frequency and selected XMP profile
frequency. Only valid if an XMP Profile is selected.
Configuration options: [Disabled] [Enabled]
SA GV
System Agent Geyserville. Can disable, fix to a specific point, or enable frequency
switching. If enabled, we recommend you to leave options at parked values for best
compatibility. Enabling this feature requires a longer boot time.
Configuration options: [Disabled] [Enabled] [Fixed to 1st Point] [Fixed to 2nd Point]
[Fixed to 3rd Point] [Fixed to 4th Point]