Asus ProZ790-CREATOR WIFI LGA 1700 ATX Motherboard - Manual (Page 37)

PRIME / ProArt / TUF GAMING Intel 700 Series BIOS Manual 37
CPU VRM Thermal Control
Disable to increase the temperature limit of the CPU VRM.
Configuration options: [Auto] [Enabled] [Disabled]
DO NOT remove the VRM heatsink.
The following items appear only when using the onboard graphics.
CPU Graphics Load-line Calibration
The load-line is defined by the Intel VRM specification and affects the CPU Graphics
power voltage. The CPU Graphics working voltage will decrease proportionally
depending on the CPU Graphics loading. Higher levels of the load-line calibration
can get a higher voltage and a better overclocking performance but increase the CPU
Graphics and VRM thermal production. Select from level 1 to 8 to adjust the CPU
Graphics power voltage from 100% to 0%.
Configuration options [Auto] [Level 1] [Level 2] [Level 3] [Level 4:Recommended for
OC] [Level 5] [Level 6] [Level 7]
Boosted performance may vary depending on the CPU Graphics specification. DO NOT
remove the thermal module.
CPU Graphics Current Capability
The CPU Graphics current capability adjusts the total power range for CPU Graphics
overclocking. A higher value provides a wider total power range and extends the
overclocking frequency range simultaneously.
Configuration options: [Auto] [100%] - [140%]
Configure higher values when overclocking or under a high CPU Graphics loading for
extra power support.
CPU Graphics VRM Switching Frequency
The switching frequency will affect the CPU Graphics transient response speed
and the component thermal production. Select manual mode to configure a higher
frequency to get a quicker transient response speed.
Configuration options: [Auto] [Manual]
DO NOT remove the thermal module when setting this item to [Manual] . The thermal
conditions should be monitored.
The following item appears only when CPU Graphics VRM Switching Frequency is set
to [Manual] .
Fixed CPU Graphics Switching Frequency(KHz)
The switching frequency will affect the CPU Graphics transient response speed and
the component thermal production. Use the <+> or <-> to adjust the value. The values
range from 250 KHz to 500 KHz with an interval of 50 KHz.