NETGEAR GS308E 8-Port Gigabit Managed Switch - Manual (Page 76)

Factory Default Settings
You can return the switch to its factory settings. Use the end of a paper clip or some
other similar object to press and hold the
Factory Defaults
button on the front panel
of the switch for at least two seconds. The switch resets and returns to the factory settings
that are shown in the following table.
Table 9. Factory default settings
Setting Feature
password Switch password
192.168.0.239 (if the switch is not connected to a network with a DHCP server) IP address
255.255.255.0 Subnet mask
Enabled DHCP mode
Enabled IGMP snooping
None configured LAGs
Disabled. If enabled, by default, all ports are members of VLAN 1. VLANs
Enabled 802.1p/DSCP-based QoS
Disabled Port-based QoS
Disabled Rate limiting
Disabled Broadcast filtering
Disabled Loop detection
Autonegotiation Port speed
Disabled Flow control
Disabled Port mirroring
User Manual 76 Factory Default Settings and
Technical Specifications
Gigabit Ethernet Smart Managed Plus Switches