Pioneer Toraiz SQUID - Creative Multitrack Sequencer - Manual (Page 67)

Step edit section
67
En
INTERPOLATION
By setting each parameter for the steps of the beginning, middle and
end points, the unit automatically interpolates parameters for the steps
in-between them.
The following parameters can be interpolated using this function.
• PITCH value
• GATE value
• VELOCITY value
• The control values of the controller numbers assigned to the CC1 to
CC3 knobs
For the Interpolation function, use the following buttons in the
[INTERPOLATION] section.
Notes
• The interpolation result varies depending on settings of the Running
Direction function (page 95).