HP 3500YL User Manual
Page 185
IP Routing Features
Overview of IP Routing
Parameter
Description
Default
See page
Proxy ARP
An IP mechanism a router can use to answer an ARP
request on behalf of a host, by replying with the
router’s own MAC address instead of the host’s.
Disabled
Time to Live
(TTL)
The maximum number of routers (hops) through
which a packet can pass before being discarded.
Each router decreases a packet’s TTL by 1 before
forwarding the packet. If decreasing the TTL causes
the TTL to be 0, the router drops the packet instead
of forwarding it.
64 hops
Refer to the
chapter titled
“Configuring IP
Addressing” in
the Management
and Configuration
Guide.
Directed
broadcast
forwarding
A directed broadcast is a packet containing all ones
(or in some cases, all zeros) in the host portion of the
destination IP address. When a router forwards
such a broadcast, it sends a copy of the packet out
each of its enabled IP interfaces.
Note
: You also can enable or disable this parameter
on an individual interface basis. See table 5-2 on
page 5-14.
Disabled
ICMP Router
Discovery
Protocol
(IRDP)
An IP protocol that a router can use to advertise the
IP addresses of its router interfaces to directly
attached hosts. You can enable or disable the
protocol at the Global CLI Config level.
You also can enable or disable IRDP and configure
the following protocol parameters on an individual
VLAN interface basis at the VLAN Interface CLI
Config level.
• Forwarding method (broadcast or multicast)
• Hold time
• Maximum advertisement interval
• Minimum advertisement interval
• Router preference level
Disabled
Static route
An IP route you place in the IP route table.
No entries
Default
network
route
The router uses the default network route if the IP
route table does not contain a route to the
destination. Enter an explicit default route (0.0.0.0
0.0.0.0 or 0.0.0.0/0) as a static route in the IP route
table.
None configured
5-11