HP 3500YL - Manual (Page 244)

IP Routing Features
Configuring OSPF
Syntax: vlan < vid ># ip ospf [ ip-addr | all ] area < ospf-area-id >
Executed in a specific VLAN context to assign the VLAN or
individual subnets in the VLAN to the specified area. Requires
that the area is already configured on the routing switch (page
5-65). When executed without specifying an IP address or using
the
all keyword, this command assigns all configured networks
in the VLAN to the specified OSPF area.
vlan < vid >: Defines the VLAN context for executing the area
assignment.
[ ip-addr ]: Defines a specific subnet on the VLAN to assign to a
configured OSPF area.
[ all ]: Assigns all subnets configured on the VLAN to a configured
OSPF area.
area < ospf-area-id >: Identifies the OSPF area to which the VLAN
or selected subnet should be assigned.
Notes: If you add a new subnet IP address to a VLAN after
assigning the VLAN to an OSPF area, you must also assign
the new subnet to an area. If all subnets in the VLAN should
be assigned to the same area, just execute
ip ospf area < ospf­
area-id >. But if different subnets belong in different areas, you
must explicitly assign the new subnet to the desired area. Also,
to assign a VLAN to an OSPF area, the VLAN must be
configured with at least one IP address. Otherwise, executing
this command results in the following CLI message:
OSPF can not be configured on this VLAN.
Example: To assign VLAN 8 on a routing switch to area 3 and include all IP
addresses configured in the VLAN, enter the following commands:
ProCurve(ospf)# vlan 8
ProCurve(vlan-8)# ip ospf area 3
Example. Suppose that a system operator wants to assign the three subnets
configured in VLAN 10 as shown below:
■ 10.10.10.1 to OSPF area 5
■ 10.10.11.1 to OSPF area 5
■ 10.10.12.1 to OSPF area 6
5-70