HP 3500YL - Manual (Page 92)

PIM-DM (Dense Mode)
Displaying PIM Data and Configuration Settings
Syntax: show ip pim [interface [< vid >]]
Displays the current configuration for the specified VLAN
(PIM interface). Refer to table 3-1, below.
ProCurve(config)# show ip pim interface 29
PIM Interface
VLAN : 29
IP Address : 10.29.30.1
Mode : dense
Hello Interval (sec)
Hello Delay (sec)
: 30
: 5
Graft Retry Interval(sec) : 3
Max Graft Retries : 2
Override Interval (msec) : 2500
Propagation Delay (msec) : 500
SR TTL Threshold : 2
Lan Prune Delay
Lan Delay Enabled
State Refresh Capable
: Yes
: No
: No
Figure 3-12. Example Output for Routing Switch “#1” in Figure 3-4 on Page 3-20
Table 3-1. PIM Interface Configuration Settings
Field Default Control Command
VLAN n/a vlan < vid > ip pim-dense
IP n/a vlan < vid > ip pim-dense < any | ip-addr >
Mode dense PIM-Dense or PIM-Sparse
Hello Interval (sec) 30 ip pim-dense hello interval < 5 - 30 >
Hello Hold Time 105 The routing switch computes this value from the current “Hello
Interval” and includes it in the “Hello” packets the routing
switch sends to neighbor routers. Neighbor routers use this
value to determine how long to wait for another Hello packet
from the routing switch. Refer to the description of the Hello
Interval on page 3-15.
Hello Delay 5 vlan < vid > ip pim-dense hello delay < 0 - 5 >
Graft Retry Interval
(sec) 3 vlan < vid > ip pim-dense graft-retry-interval < 1 - 10 >
Max Graft Retries 2 vlan < vid > ip pim-dense graft-retries < 1 - 10 >
3-30