HP 3500YL - Manual (Page 290)

IP Routing Features
Configuring OSPF
Example:. To get OSPF virtual link information for IP address 10.0.8.33,
enter show ip ospf virtual-link 10.0.8.33. A display similar to the following is
shown.
ProCurve# show ip ospf virtual-link 10.0.8.33
OSPF Virtual Interface Status for interface 10.0.8.33
Transit AreaID : 10.3.16.0
Neighbor Router : 10.0.8.33
Authentication : none Chain :
Interface State : P2P Transit Delay : 1
Events : 1 Rtr Interval : 5
Dead Interval : 40 Hello Interval : 10
Figure 5-52. Example of Output for Show IP OSPF Virtual-Link < ip-addr >
In this display, these fields show the same type of information as described
for the general OSPF virtual link display:
Transit Area ID, Neighbor Router,
Authentication, and Interface State. This display shows the following additional
information:
Table 5-20. CLI Display of OSPF Virtual Link Information – Specific IP Address
Field
Events
Transit delay
Rtr Interval
Hello Interval
Dead Interval
Description
The number of times the virtual link interface state has changed.
The configured transit delay for the virtual link.
The configured retransmit interval for the virtual link.
The configured hello interval for the virtual link.
The configured router dead interval for the virtual link
5-116