HP 3500YL - Manual (Page 380)

Virtual Router Redundancy Protocol (VRRP)
Error Messages
Error Messages
Track Interface
Message Description
VR must be defined as “backup” first You have to declare a VR as Backup before assigning a
track interface to it.
Invalid input: <out of range value> You have to assign a valid port or trunk to the VR instance.
VR operation must be “down” prior to modifying VR’s You cannot change the track interface when the VR is
parameters active. Use the no enable command to disable the VR.
Can’t track a port that is part of a trunk You can’t configure tracking on a port that is a member of
a trunk.
Tracking is disabled on owner You can’t configure a track interface on an Owner VR.
Cannot remove trunk being tracked by VRRP You can’t remove a trunk that is being tracked by a VR
Cannot enable LACP on a VRRP tracked port You can’t enable LACP on a port that is being tracked by a
VR.
Too many entities to track You have selected too many entities to be tracked by the
VR.
Cannot track trunk/LACP member You can’t track the specified trunk or LACP member.
VRRP tracked port is not allowed in trunk You can’t add this tracked port to a trunk.
VRRP tracked port is not allowed in LACP You can’t use LACP with the tracked port.
Operation is not permitted on VR when it is configured as The VR must be a Backup and initialized in order to execute
owner or is uninitialized. the operation.
6-50