Back – MRV Communications TERESCOPE TS800/155 User Manual
Page 13
M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l
3
HIG H
VOLT.
LO W
VOLT.
MRV
Switch
Ip
Address
Fast
Ethernet
Position
Data Rate
UP
Normal
DOWN
Local
Loopback
1
2
3
Mode of
Default IP
ATM
OC3
E3
T3
4,5
4
5
Normal
Alignment
-
4,5
-
4
5
TX RX
TELESCOPE
TORQUE VALUE 7 Lb-Inch
L G N
+/~
-/~
USE COPPER CONDUCTORS ONLY
POWER
OPTICAL POWER
SYNC
FLAG
FIBER OPTIC
NOT IN
USE
MANAGEMENT
1762310-SC
SYNC
FLAG
AIR RX
F/O RX
G
2. Back
All models of the TereScope are SNMP manageable. SNMP monitoring can be
performed using MRV’s MegaVision SNMP management application.
A. TS700/155 (Standard Model)
The TS700 supports Fast Ethernet, OC3, STM1, E3, and T3 protocols in the 34-
155 Mbps range. A special type of TS700 can be ordered that can be used for
Open Protocol applications which ensures complete transparency (including all
data in the range of 1-155 Mbps.) In this type, less than 2 dB of the budget is
lost.
Figure 1.2b: Rear View of TS700/155
Main Data:
SC or ST
Connector
DIP Switch
Toggles 6,7,8
positions are
not used.
Figure 1.2a: TS700/155 Standard Model Panel Schematic
If you need to install the
SNMP card into the
TereScope, after installing
the card and before
closing the back panel,
carefully punch out this
piece of metal.