MRV Communications TERESCOPE TS800/155 - Manual (Page 23)

M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l
13
E. TS700/G - Gigabit-Ethernet System
The TereScope 700/G supports Gigabit Ethernet and FiberChannel
protocols. The physical design and configuration of the TS700/G is similar to
the other members of the series, and its operational principles are essentially
the same. However, The TS700/G only offers a duplex fiber interface. The
standard is 850nm SC multimode. (850nm ST multimode, 1310nm and
1550nm SC singlemode are available on request).
HIGH
VOLT.
LOW
VOLT.
MRV
Switch
Ip
Address
Not
Used
Data
Rate
4
Gigabit
Ethernet
Default
Attenuated
Normal
IP
Software
IP
Fiber
Channel
1.0625
Position
UP
DOWN
1 2 3
Mode
Transmitter
TX RX
TELESCOPE
TORQUE VALUE 7 Lb-Inch
L G N
+/~ -/~
USE COPPER CONDUCTORS ONLY
POWER
AIR
FLAG
F/O
FLAG
LASER
ENABLED
POWER
OPTICAL POWER
DRY-CONTACT
LASER
ENABLED
FLAG
FIBER OPTIC
MANAGEMENT
1762318-SC
FLAG
AIR RX F/O RX
G
Figure 1.7: TS700/G Model Back Panel
Table 5: TS700/155 Standard Model Back Panel Controls, Interfaces, and Indicators
Power Power source Terminal Block (Main or UPS)
AC power supply (100 to 240 Vac) or DC power
supply (24 to 60 Vdc)
Fiber optic Fiber Optic interface for connection to the
peripheral equipment.
The standard interface is MM 850nm SC connector;
other interfaces are available upon request.
Management
(Standard) Connection to 10base-T SNMP management
interface.
Connectors
Dry Contact There are 4 pairs of dry contact indicators available:
# Power
# Air RX Link LED
# F/O Flag LED
# Laser Enabled
Dry contacts are normally closed (25 ohms), and
open in an alarm condition